Filter
Top Products
Installation
Runco LS-1 Installation/Operation Manual 29
PRE
L
IMINAR
Y
3.6
Connections to the
LS-1
Proceed as follows to connect the LS-1 to your video sources, external controller(s) – if
present – and AC power.
When connecting your equipment:
• Use the correct signal cables for each source.
• For best performance and to minimize cable clutter, use high-quality cables that are
only as long as necessary to connect two devices. (Don’t use a 20-foot cable when a
6-foot cable will suffice.)
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
Connector Panel AccessUsing a flat-blade screwdriver, loosen the two
screws holding the rear compartment cover
in place.
Using a flat-blade screwdriver, loosen the two
screws holding the rear compartment cover
in place.
Then, remove the rear compartment cover by
tilting it upward.