Filter
Top Products
Operation
52 Runco LS-1 Installation/Operation Manual
PRE
L
IMINAR
Y
Memory: Select Memory from the Main menu, then press ENTER to recall image quality
settings previously saved, or to save changed settings in any of four memory locations.
• Recall Memory: Select Recall Memory from the Memory menu to recall saved image
quality settings. Unless you select Default (see below), this control affects all sources,
not just the active source.
• User Memory 1 and User Memory 2 contain the factory default settings when the
projector is initially turned on.
• When you recall the ISF Day or ISF Night memory settings, all settings associated
with these stored values are grayed out. This prevents unintended adjustments from
being made. To remove this restriction, choose User Memory 1 or User Memory
2.
ISF Day and ISF Night are grayed out unless these custom settings have already
been saved.
•Choose Default to restore the factory-default settings for the active source only.
The other sources are unaffected.
• Save Settings: Select Save Settings from the Memory menu to save any
image-related settings you have changed to User Memory 1 or User Memory 2.
The following items are saved (for all sources, not just the active source):
• Brightness / Contrast
• Color / Color Tint
• Sharpness (all settings in sub-menu)
• Noise Reduction (all settings in sub-menu)
• Color Space
• Video Standard
• Gamma
• Color Temperature
• DLP Frame Rate
• Color Gamut
• SatCo
• ConstantContrast
• Adaptive Contrast
• RGB Adjust (all settings in sub-menu)
• Save ISF: Select Save ISF from the Memory menu to save any image-related settings
you have changed to the ISF Day or ISF Night memory location.
The settings that are saved are the same as those saved with the Save Settings
command (see above).
You must enter a passcode to access the Save ISF
sub-menu.
Note