Filter
Top Products
Installation
Runco LS-HB/LS-HB Ultra Installation/Operation Manual 15
PRE
L
IMINAR
Y
3.2
Quick Setup
Table 3-1 gives a quick overview of the LS-HB installation process. The sections following
this one provide detailed instructions.
Installation should be performed by a qualified custom video
installation specialist.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer
to page...
1
Choose a location for the projector 16
2
Install primary projection lens 21
3
Install anamorphic lens mounting assembly (optional) 24
4
Mount the projector 30
5
Connect signal sources to the LS-HB 33
6
Connect external controller to RS-232 port and/or IR repeater
system (optional)
38
7
Connect 12-volt trigger output to retractable screen or other,
+12V trigger-activated equipment (optional)
39
8
Apply power to the projector 40
9
Primary lens adjustments: projected image size (zoom), position
(shift) and focus
19, 41
10
Change the OSD Language (optional) 42
11
For rear-screen and/or ceiling-mount installations, select the
proper picture orientation
42
12
Install and adjust secondary anamorphic lens (optional) 43
13
Projector calibration: adjust the following for each input; save
settings when finished:
• Aspect ratio
•Brightness
•Contrast
• Color level
•Tint
•Sharpness
• White Balance
50
Note