Filter
Top Products
Installation
Runco LS-HB/LS-HB Ultra Installation/Operation Manual 41
PRE
L
IMINAR
Y
3.8
Turning on the Power
1. Turn on your source components.
2. Press the ON button on the remote control to turn on the LS-HB. The LED
flashes green to indicate that it is warming up.
3. When the projector is ready for use, the LED turns off.
3.9
Primary Lens
Adjustments
The LS-HB gives you a great deal of control over the picture size, position and focus.
Focus and ZoomTo focus the projected image, grasp the lens
by the front ring and rotate it.
To make the picture smaller (zoom out) or
larger (zoom in), rotate the zoom ring in the
appropriate direction.
Lens ShiftTo access the lens shift controls:
1. Locate the Runco badge at the top of the
projector. Press on the side of the badge
nearest the “R” to release it.
2. Carefully lift the badge up, then away from
the projector.
Vertical Lens Shift: To shift the projected
image vertically, insert the provided hex
wrench into the hole at the top of the projector
(directly above the lens). Then, turn the
wrench as shown to shift the lens in the
desired direction.
When you have finished adjusting the lens position, re-install the Runco badge.
ON
l
Zoom Out
Zoom In
Focus