Filter
Top Products
Operation
48 Runco LS-HB/LS-HB Ultra Installation/Operation Manual
PRE
L
IMINAR
Y
4.4
Using
Picture-In-Picture (PIP)
For PIP purposes, there are three groups of inputs
separated by their display modes:
•Video (SD) group: Video, S-Video and SCART
inputs.
• Graphic (HD) group: Component 1 and RGB inputs.
• Digital Video group: HDMI 1 and HDMI 2 inputs.
PIP shows one input from any of these groups within or beside one input from either of the
other two groups.
• Press PIP to enable the PIP function. Once enabled, press PIP repeatedly to select the
desired PIP source or turn PIP off.
• Press SWAP to swap the main and PIP images.
For more information, refer to PIP Position on page 66.
For each source, Table 4-1 shows which of the other sources are available as a PIP
source.
Table 4-1. Available Main and PIP Source Combinations
PIP Input Source
VIDEO S-VIDEO SCART COMP 1 RGB HDMI 2 HDMI 1
Main Input Source
VIDEO
– – –
√√√√
S-VIDEO
– – –
√√√√
SCART
– – –
√√√√
COMP 1
√√√
– –
√√
RGB
√√√
– –
√√
HDMI 2
√√√√√
– –
HDMI 1
√√√√√
– –
Notes:
1. “
√
” means that that source is available as a PIP source with a given main source; “–” means that
it is not.
2. Disabled sources (refer to Source Enable on page 65) are not available as PIP sources.
PIP SWAP LIGHT