Filter
Top Products
Installation
Runco VX-44d/-55d Owner’s Operating Manual 29
PRE
L
IMINAR
Y
3.7
Connections to the
VX-44d/-55d and DHD
Controller
Proceed as follows to connect the DHD Controller to the VX-44d/-55d, your video
sources, external controller(s) – if present – and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
Connector Panel AccessTo access the connector panel, pull firmly on the cable access cover to open it.
Connecting the DHD
Controller to the
VX-44d/-55d
Connect the HDMI and RS-232 outputs from the DHD Controller to the corresponding
inputs on the VX-44d/-55d; see
Figure 3-8.
Figure 3-8. Connecting the VX-44d/-55d to the DHD Controller
Pb Pr Y
Video
3
IR
RS-232 Control
S-Video 1
S-Video 2
HD1
HD2
1
2
R/Pr G/Y B/Pb
R/Pr G/Y B/Pb H V
HDMI 1 HDMI 2HDMI Out
HV
TRIGGERS
RS-232 Out
CAUTION:
TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE CENTER.
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
!
WARNING:
TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
100-230VAC 50-60 Hz, 165 Watts Max
INPUTS
SYSTEM CONTROL INTERFACE
Component Video
SDI
Option
Serial No
Video Processor / Controller
Model
Made In USA
HDMI OUT
RS-232
OUT