Filter
Top Products
Installation
44 Runco VX-44d/-55d Owner’s Operating Manual
PRE
L
IMINAR
Y
3.12
Calibrating Projector
Input
2 (DVI)
After you have installed and adjusted the projector and lens (or lenses), you are ready to
begin calibrating the DVI input (Input 2) to the VX-44d/-55d.
To perform the calibration, you will use the projector rear-panel keypad (Figure 2-3) or
TheaterMaster Remote Control, shown in Figure 3-16 and described on the pages that
follow. Once you have completed the projector input calibration, the end user can use the
DHD Controller Remote Control (
Figure 2-6) to adjust input image quality, change aspect
ratios, switch between sources and more. (The exception to this rule is when sources are
connected directly to the projector. Although this is technically possible, Runco advises
against this.)
Runco calibrates both the VX-44d/-55d and DHD Controller at the
factory for optimum performance in most typical home cinema
environments, before the system ships.
Carefully assess the displayed image quality before proceeding with
calibration. In most cases, it is not necessary to calibrate the
projector inputs, as the DHD Controller gives you as much control
as you will need over the image quality.
Only ISF-certified installation technicians should attempt the
calibration procedures described here, and ONLY if absolutely
necessary to accommodate an atypical installation.
Note