Filter
Top Products
15
Basic setup
Setting up the surround sound system
You must connect all the speakers and setup the system
properly in order to en
j
oy the di
g
ital cinema experience
at home.
Note: Use the test tone mode to check the balance level
and connections of your speakers. (Refer to page 17 ).
Position
For the best possible surround sound, normally all the
speakers other than the subwoofer should be placed the
same distance from the listening position.
This system allows you to place the center speaker up to
4 feet closer
B
, and the rear speakers up to 16 feet
closer
C
to the listenin
g
position. The front speakers
can be placed from 3 to 45 feet
A
from the listenin
g
position.
It is best to place the subwoofer near a corner to
maximize the bass output.
45
o
20
o
90
o
A A
B
C
C
Place the rear speakers either behind or to the side of the
listening position, depending on the shape of the room
(as illustrated).
45
o
20
o
90
o
AA
B
C
C
Height
The recommended hei
g
ht to place the center, front and rear
speakers is level with your ears while in a seated position.
If necessary, the rear speakers may be placed sli
g
htly hi
g
her
than the center and front speakers. Note the area labeled
C
in the diagram below:
30
o
60
o
C
D
C
D
Balance
To set the channel levels, you will be adjusting the volume
level on each speaker to achieve balance.
Using the remote control unit, press the SELECT button to
select a channel as follows:
FL (front left) ÖCNT (center) Ö FR (front right) Ö SR
(surround right) Ö SL (surround left) Ö SUB (subwoofer).
The level of the selected channel will be displayed on the
television screen and on the front panel display.
Use the VOLUME+ button to ad
j
ust the selected channel’s
level between 00dB and +10dB as follows: 00DB Ö
+01DB Ö +02DB Ö +03DB Ö +04DB Ö +05DB Ö +06DB
Ö +07DB Ö +08DB Ö +09DB Ö +10DB.
Use the VOLUME- button to adjust the speaker channel’s
level between 00dB and -10dB as follows: 00DB Ö -01DB Ö
-02DB Ö -03DB Ö -04DB Ö -05DB Ö -06DB Ö -07DB Ö
-08DB Ö -09DB Ö -10DB.
Notes:
xThe default setting is 00DB. We suggest that you set you
subwoofer to +05DB for better balance.
xIf you do not press the SELECT, VOLUME + or
VOLUME – button after a few seconds, the value turns off
and is stored in the system.
xTo adjust the master volume (the volume of all the
speakers at once) use the VOLUME + and VOLUME –
buttons in normal mode.