Filter
Top Products
28
Other functions
Operating the radio
The receiver has a built-in tuner that allows for AM/FM
radio function.
Manual tuning
1. Connect the FM and AM antenna accordinglyΰsee
“Connecting the Antenna” on page 12 section for
detailsα
2. Press the POWER button to switch on the receiver.
3. Press the SOURCE button to enter TUNER mode.
4. To select band, press the SOURCE button to to
gg
le
between AM/FM modes.
5. Tune the stations by pressing the TUNE or TUNE
buttons repeatedly until the desired station is found.
NOTE: To activate the automatic search function, press
and hold the TUNE or TUNE buttons for about 2
seconds. In this mode the receiver will automatically
tune frequencies until it finds a station.
Selecting Mono or Stereo Sound
Press the AUDIO (ST/MO) button on the remote
control to switch between mono and stereo sound in FM
tuner mode (when available).
Note: After pressing the TUNE or TUNE , MEM or
MEM buttons, the listenin
g
mode will automatically
change to stereo.
Storing radio stations:
You can easily enter and store up to 40 AM or FM radio
stations in the receiver’s memory.
POWER
A
UDIO(ST/MO)
SOURCE
TUNE +/-
MEM +/-
NUMBER
BUTTONS
Manual preset
1. Select FM or AM band by pressing the SOURCE button
repeatedly.
2. Tune to the radio station to be stored by pressin
g
the
TUNE or TUNE buttons on the remote control.
3. Press the SLOW/MEM button on the remote control.
“
PROG” and the preset number will appear on the front
panel display.
4. Press the MEM, MEM, or enter the number buttons
ΰ0~9, >10α, while “PROG” is still appearing to select
the desired preset memory location.
5. Press the SLOW/MEM button on the remote control to
store a frequency in the preset location.
6. Repeat steps 1-5 to store other frequencies.
Retrieving preset stations
1. Press the SOURCE button to select tuner mode.
2. Press the MEM or MEM buttons on the front panel
or remote control to select preset stations.
POWER
SOURCE SKIP/TUNING +/-