Filter
Top Products
31
Trouble Shootin
g
If you experience any of the followin
g
difficulties while
usin
g
the system, use this troubleshootin
gg
uide to help
you remedy the problem. Should any problem persist,
consult your nearest service center.
No power
x Is the power cord firmly plugged into the power outlet?
x One of the safety mechanisms may be operatin
g
. In
this event, unplu
g
the player from the power outlet
briefly and then plug it in again.
No picture
x Check that the system is connected securely.
x The video connecting cord is damaged.
Replace it with a new one.
x Make sure you connect the system to the video input
connector on the TV.
x Make sure you turn on the TV.
x Make sure you select the video input on the TV so that
you can view the pictures from this system.
Noiseΰinterferenceαappears in the picture
x Clean the disc.
x If video from this system has to
g
o throu
g
h your VCR to
get to your TV, the copy-protection applied to some
DVD pro
g
rams could affect picture quality. If you still
experience problems after checking your connections,
please try connectin
g
your DVD system directly to your
TV S-Video input, if your TV is equipped with this input.
The aspect ration of the screen cannot be
chan
g
ed even thou
g
h you set “TV DISPLAY” in
the SETUP menu when you play a wide picture
x The aspect rate is fixed on your DVD disc.
x If you connect the system with the S-Video cable,
connect directly to the TV. Otherwise, you may not
change the aspect rate.
x Dependin
g
on the TV, you may not be able to chan
g
e
the aspect ration.
There is no sound or only a very low-level sound
is heard
x Check that the speakers and components are
connected securely.
x Make sure that you have selected the correct source on
the system.
x Press MUTE button on the remote control if the
g
reen
STANDBY LED on the front panel is turn on.
x The protective device on the system has been activated
because of a short circuit. Turn off the system, eliminate
the short-circuit problem and turn on the power again.
x The audio connecting cord is damaged. Replace it with a
new one.
x The system is in pause mode or in slow-motion play mode,
of fast forward or fast reverse is performed. Press
PLAY/PAUSEΰ/αto return to normal play mode.
x Check the speaker settings.
The left and right sounds are unbalanced or
reversed
x Check that the speakers and components are connected
correctly and securely.
x Adjust front balance parameter using SELECT and
VOLUME +/- buttons.
The surround effect is difficult to hear when you are
playing a Dolby Digital sound track.
x Check the speaker connections.
x Dependin
g
on the DVD disc, the output si
g
nal may at
times be monaural or stereo even if the sound track is
recorded in Dolby Digital format.
The sound comes from the center speaker only
x Depending on the disc at times the sound may come from
the center speaker only. This is normal.
x Adjust the center speaker volume.
No sound or only a very low-level sound is heard
from the rear speakers
x Adjust the rear speaker volume.
Radio stations cannot be tuned in
x Check that the antennas are connected correctly. Ad
j
ust
the antennas and connect an external antenna if
necessary.
x The signal strength of the stations is too weakΰwhen
tuning in with automatic tuningα. Use manual tuning.
x No stations have been preset.
x The tuner mode is not selected, select the tuner mode.
The remote does not function
x Remove any obstacles between the remote control and
the system.
x Move the remote control closer to the system.
x Point the remote control at the remote sensor on the front
panel.
x Replace all the batteries in the remote control with new
ones if they are weak.
x Check that the batteries are loaded correctly.