Filter
Top Products
55
You can record a TV show in progress by inserting a blank tape and
pressing the REC button. You can even add time in 30-minute
increments up to 4 hours by pressing the REC button repeatedly;
see page 57.
NOTE: Be sure your videotape has a Record Safety Tab. If the tab
is missing, you can cover the opening with a small piece of
tape. Warning: Do not cover this opening unless you are
sure you want to record over the tape.
Before You Begin...
• Power on the DVD-VCR
• Power on the TV
• Set the TV to channel 3 or 4 .
1 Insert Tape
Insert a blank VHS tape into the VCR deck.
• Make sure the tape is long enough to record the entire program.
To change the Recording Speed, see page 57.
2 Select a Channel to Record
Use the 0–9 buttons or the Channel Up/Down arrow buttons to
select the desired channel, or press the INPUT SEL. button to
select Line 1 or 2 if recording from an external device connected to
the front or rear Line inputs, respectively.
3 Start Recording
Press the REC button on the remote control or front panel.
For options while recording is in progress, see “Special Recording
Features” on the next page.
➢ Recording from the DVD player to the VCR is not
possible.
Basic Recording
CHANNEL
LINE IN 2
DVD/VCR
PROGRESSIVE
1
2
3
54
Press the SEARCH button to display the search screen in the stop
mode. When a program is recorded, the starting point is given an
Index mark for easy location. However, the VHS Index Search
System (VISS) cannot recognize index marks made by old VCRs. If
the VCR has trouble finding a mark, it is probably because the
cassette was recorded on a VCR without VISS. If you want to index
two programs in a row, set your VCR to stop, then start recording
each program. Pause has no effect on index marks.
1 Go to 0:00:00 stop
Use this feature when you want to search for the 0:00:00 counter
position on a cassette. Press the CLEAR button at the point on the
tape where you want to set the counter to 0:00:00. While a
cassette is stopped, press the ENTER button. The VCR will rewind
or fast forward, searching for the 0:00:00 counter position, and then
automatically stop at that position.
2 End search
Use this feature when you want to search for a blank position to
record a program on a cassette. While a cassette is stopped, press
ENTER button. The VCR will fast forward, searching for a blank
position, and then automatically stop at that position. If the VCR
reaches the end of the tape during end search, the tape will be
ejected.
3 Scan and play
Use scan and play when you don’t know exactly where a program
is located on a cassette tape.
- Forward Intro Scan
Highlight “Forward Intro Scan”, then press the ENTER button.
- Reverse Intro Scan
Highlight “Reverse Intro Scan”, then press the ENTER button.
Variable Search System
Forward
Reverse
3