Filter
Top Products
28 English
Setup
Initial Settings
Turn on your TV after connecting the product.
When you connect and turn on the product to a
TV for the fi rst time, the Initial Settings screen
appears.
Initial Settings | On-Screen Language
m
Move
"
Enter
Select a language for the on-screen displays.
Български Hrvatski Čeština
Dansk Nederlands
English
Eesti Suomi Français
Deutsch Ελληνικά Magyar
Indonesia Italiano
Press the ▲▼◄► buttons to select the desired
language, and then press the ENTER button.
Press the ENTER button to select Start.
Press the ▲▼ buttons to select the desired TV
Aspect Ratio, and then press the ENTER button.
(See page 31)
If you press the BLUE (D) button to skip Musical
Room Calibration or Network Setup, you can
access the Home menu even if the Calibration or
the Network Setup is not completed.
Plug the ASC microphone into the ASC IN jack
on the product. (See page 35)
Press the ENTER button to select the Start
button.
Setting the Musical Room Calibration function
takes about 3 minutes.
Press the ▲▼ buttons to select the desired
Network Settings : Wired, Wireless
(General), WPS(PBC) or One Foot
Connection, and then press the ENTER
button. If you do not know the details of your
Network Settings, press the BLUE (D) button
on your remote instead to skip Network
Settings here, fi nish the Initial Settings, and
go to the Home menu.
If you selected a Network Settings, go to
pages 38~41 for more information about the
Network settings. When done, go to Step 8.
The Home menu appears. (For more
information about the Home menu, please
see page 29.)
1.
2.
3.
4.
5.
6.
7.
8.
Home Menu
d
WPS(PBC)
My Devices Internet Settings
Videos
Photos
Music
My Contents
Function
NOTE
The Home menu will not appear if you do not
confi gure the initial settings except as noted
below.
If you press the BLUE (D) button during the
Musical Room Calibration/network setup, you
can access the Home menu even if the
network setup is not completed yet.
If you want to display the Initial Setting screen
again to make changes, select the Reset
option. (See page 42)
If you use an HDMI cable to connect the
product to an Anynet+(HDMI-CEC)-
compliant Samsung TV and 1.) You have set
the Anynet+(HDMI-CEC) feature to On in
both the TV and the product and 2.) You have
set the TV to a language supported by the
product, the product will select that language
as the preferred language automatically.
If you leave the product in the stop mode for
more than 5 minutes without using it, a screen
saver will appear on your TV. If the product is
left in the screen saver mode for more than 20
minutes, the power will automatically turn off.
•
✎
HT-D5210C_ZA_0307.indd 28HT-D5210C_ZA_0307.indd 28 2011-03-08 12:18:232011-03-08 12:18:23