Filter
Top Products
English-60
Setting Up Your Remote Control
After it has been set up properly, your remote control can operate in
four different modes: TV, VCR, CABLE, DVD, Samsung Set-top box.
Pressing the corresponding button on the remote control allows you to
switch between these modes, and control whichever piece of equipment
you choose.
Note
The remote control might not be compatible with all DVD Players,
VCRs and Cable boxes.
This remote control is only compatible with Samsung Set-top boxes.
Setting Up the Remote to Operate Your VCR
1 Turn off your VCR.
2 Press the SELECT button and make sure that the VCR LED is
illuminated.
3 Press the SET button on your TV’s remote control.
4 Using the number buttons on your remote control, enter three digits
of the VCR code listed on page 63 of this manual for your brand of
VCR. Make sure you enter three digits of the code, even if the first
digit is a “0”.
(If more than one code is listed, try the first one.)
5 Press the POWER button on the remote control.
Your VCR should turn on if your remote is set up correctly.
If your VCR does not turn on after set-up, repeat steps 2, 3 and 4,
but try one of the other codes listed for your brand of VCR.
If no other codes are listed, try each VCR code, 000 through 089.
Note on Using Remote Control Modes: VCR
When your remote control is in “VCR” mode, the volume buttons
still control your TV’s volume.
BN68-00751C-00Eng 7/20/04 5:21 PM Page 60