English - 39
How to Install the Wall Mount Bracket
Connecting External Devices to the PDP
➢
To connect external devices such as a DVD or a Home Theater System to the PDP, please refer to following
instructions:
1 Be sure to remove the safety pins underneath the PDP.
➢
If the safety pins are not removed, the angle cannot be
adjusted. Any attempt to do so may cause damage to
the PDP.
2 Hold onto the bottom of the PDP and pull forward fully as
directed by the arrow as illustrated) to adjust the angle.
(0°~20° by 2°) Insert the Safety Pins to the front guide
holes on both sides as illustrated in figure
@
.
➢
Viewing the PDP after connecting the external devices
Remove the Safety Pins to adjust the angle to 0°, and
then secure the Safety Pins again.
☛
For safety, be sure to secure the PDP using the safety
pins. If the safety pins are not used, the PDP may fall,
causing serious injury.
s
o
n
How to
Adjust Mounting Angle
➢
Please secure the mounting bracket on the wall surface after setting its angle at 0°
1 Secure the SET to the wall mount bracket.(Please refer to the
follow ing instructions.)
2 Set the angle by pulling the upper end of the SET attached to
bracket in the direction of the arrow. (Refer to the illustration
on the right.)
3 The angle can be adjusted from 0° to 15° by ±2°.
Hold onto the middle of the PDP to
adjust the angle (not the sides of
the PDP).
BN68-01293F-00Eng 7/19/07 10:36 AM Page 39