Filter
Top Products
34
ENG
Setting up Your Display Plug and Play
Our adoption of the new VESA
®
Plug and Play solution eliminates complicated and time consuming
setup. It allows you to install your monitor in a Plug and Play compatible system without the usual
hassles and confusion. Your PC system can easily identify and configure itself for use with your display.
This monitor automatically tells the PC system its Extended Display Identification data (EDID) using
Display Data Channel (DDC) protocols.
Setting up Your PC Software (Windows only)
The Windows display-settings for a typical computer are shown below. But the actual screens on your
PC will probably be different, depending upon your particular version of Windows and your particular
video card.
On the windows screen, select in the following sequence:
Start ➞ Settings ➞ Control Panel.
When the control panel screen appears, click on
Display
and a display dialog-box will appear.
Select the Settings tab in the display dialog-box.
The two key variables that apply the PDP-PC interface are
“Resolution” and “Colors”.
The correct settings for these two variables are:
◆ Size (sometimes called “Resolution”)
1024 x 768 pixels.
◆ Color
24-bit color
(might also be expressed as “16 million colors”)
Shown at left is a typical screen for
Display dialog box.
If a vertical-frequency option exists on your display settings
dialog box, the correct value is
60 or 60 Hz. Otherwise, just
click
OK and exit the dialog box.