Filter
Top Products
4
Press the … or † button to select the
Antenna connection, then press the ENTER
button.
When selecting Cable TV system:
Press the ENTER button to start the auto
program. By default, the cable TV system
is set to “STD”.
If you want to select another type of
cable system, press the œ button and
use the … or † button to select one of
Analog or Digital “STD”, “HRC” and
“IRC”. Press the ENTER button.
5
Press the √ button to select “Start”, then
press the ENTER button to start the auto
program. The TV begins memorizing all
available stations. Press the ENTER button
at any time to interrupt the memorization
process.
Press the EXIT button to exit.
English - 35
• Air : “Air” antenna signal
Cable : “Cable” antenna signal
Air+Cable : “Air” and “Cable”
antenna signals
• If the CableCARD is inserted into the
“CableCARD” slot on the rear panel,
“Cable” and “Air+Cable” are not
available.
• STD, HRC and IRC identify various types of cable TV systems.
Contact your local cable company to identify the type of cable system
that exists in your particular area.
At this point the signal source has been selected. Proceed to “Storing
Channels in Memory”.
Auto Program
Move Enter Return
Input
Picture
Sound
Channel
Setup
Guide
Auto Program
Enter Return
Auto Program in progress
Cable Channel 44
• The TV must be connected to an
antenna in order to receive digital TV
signals. Even if a particular channel is
deleted from the memory, you can
always tune to that channel directly
by using the number buttons on the
remote control.
Stop
Select the antennas to memorize.
Air
Cable
Air+Cable
Auto Program
Move Enter Return
Input
Picture
Sound
Channel
Setup
Guide
Select the cable system.
Analog
Digital
STD ✔
HRC
IRC
STD ✔
HRC
IRC
Auto Program
Move Enter Return
Input
Picture
Sound
Channel
Setup
Guide
Start
Select the cable system.
Analog
Digital
STD ✔
HRC
IRC
STD ✔
HRC
IRC
Start
Start
Start
Start
3_BP68-00448A-01(32~53) 1/20/05 5:11 PM Page 35