Samsung SCR-3000P DVR User Manual


 
5-105-9
DIGITAL VIDEO RECORDER
3
TIMER ARCHIVE
The following illustration shows the initial settings of the TIMER ARCHIVE menu.
The Timer Backup function allows you to set the system to automatically back up the data
that is recorded on the HDD to a video tape while you are away from the system. You can
set the system to back up the desired type of event on the desired day of the week and time
at the desired sampling rate. First set TIMER ARCHIVE to ON. Next, select all event types
you want to back up by setting them to [O]. For example, a backup will not be performed,
even if an alarm event occurs during the set time, unless ALARM EVENT is set to [O]. Set
ARCHIVE SCHEDULE by selecting one from the following: SUN, MON, TUE, WED,
THU, FRI, SAT, MON-FRI, MON-SAT, and DAILY. Enter the backup start and end times
into FROM and TO fields respectively. Finally, set the picture sampling rate to the desired
value between 1/1 to 1/16.
To cancel the TIMER ARCHIVE you have set, press the STOP(
) button for 3 seconds. The
TIMER ARCHIVE will pause for 5 seconds. However, if you do not make any action for 5
seconds, the system will reset to the Timer Archive after 5 seconds have elapsed. To com-
pletely cancel the TIMER ARCHIVE, enter the menu within 5 seconds and set the
TIMER ARCHIVE to OFF.
Because TIMER ARCHIVE is an automatic backup for the data that will be recorded, any
data that has already been recorded will not be backed up. The following illustrates the
timeline of TIMER ARCHIVE.
The TIMER ARCHIVE time is a future time, rather than the current time. If the time you set
is earlier than the current time, it is tomorrow's time or a time in the next week. In the above
illustration, the TIMER ARCHIVE time is set and there are 3 record events. The first event
overlaps with the TIMER ARCHIVE start time. In this case, archiving will start at the start
time of the record event that is overlapping. Archiving will start as an event ends. The third
event is overlapping with the end time of TIMER ARCHIVE. In this case, only the data
between the event start time and archiving end time will be archived when the TIMER
ARCHIVE set time ends, even if the record event is not finished.
TIMER ARCHIVE
TIMER ARCHIVE OFF
SELECT EVENT RECORD [X]
ALARM [X]
MOTION [X]
DAY SUN
FROM 12:00:00
TO 12:00:00
SAMPLING RATE 1/1
MOVE=[//
/
] SELECT=[ ] EXIT=[MENU]
Note
Note
- If MULTIPLEXER in the SYSTEM SETUP menu of the DVR MAIN MENU is set to
WITH, the MOTION event type will be disabled for SELECT EVENT of the TIMER
ARCHIVE menu.
Current Time
Date being archived
RECORD EVENT
TIMER ARCHIVEE
End Time
TIMER ARCHIVE
Start Time