Samsung SHR-2041 DVR User Manual


 
5-30
Note
Note
If you want to connect IP Router with the main body of SHR-2040/2041/2042, you shall
designate a port for SHR-2040/2041/2042 in the IP Router setup menu.
The main body of SHR-2040/2041/2042 uses 4 ports for TCP communication.
In addition, if you want to use the DHCP function backed by IP Router to allocate Dynamic IP to
the main body of SHR-2040/2041/2042, you shall designate a port for the IP which
SHR-2040/2041/2042 has been allocated by the IP Router setup menu.
If you use IP Router, you are recommended to rather determine IP and Port numbers to be
allocated to the main body of SHR-2040/2041/2042 from the IP Router setup menu, set the
connection mode to Static IP for the main body of SHR-2040/2041/2042, and input the
determined IP and Port number in IP Router than use the DHCP function.
Please refer to the IP Router User’s Manual or call the manufacturer to set up IP Router.
Transfer Protocol Settings
You may select either TCP or UDP for the protocol type.
If you select ADSL from the IP setup page, only TCP is available.
While TCP is selected, Audio transmission is not available.
The available Port(TCP) ranges from 554 to 998 and the port number will be changed by 4.
Once the first digit is determined, the following 3 digits will change accordingly.
The available Port(TCP) ranges from 8000 to 9760 and the port number will be changed by 160.
Once the first digit is determined, the remaining digits will change accordingly.
Unicast is set to the default value and Multicast can be selected in Unicast / Multicast.
Multicast IP will be activated and its setup is available only when Multicast is selected from
Multicast/Unicast.. Select a number from 224.0.0.0 to 239.255.255.255 for the D-Class IP
address.
TTL will be also activated and the value from 0 to 255 can be set only when Multicast is selected
from Multicast / Unicast. The default value is 5.
SHR-2040/2041/2042-ENG-1 2005.6.29 4:59 PM Page 5-30