Samsung SIR-S4080R DVR User Manual


 
100
Chapter 6
Messages and Setup
then reporting through a cell phone or walkie-talkie to the person who is adjusting the
satellite dish antenna.
When you first come to this screen, it shows signal strength for the transponder that carries
the current channel. If you are having trouble with a specific channel, tune to that channel,
then come to this screen to check the signal for that transponder.
To change the transponder, use the UP arrow to highlight the transponder number.
Press the RIGHT or LEFT arrow to change the transponder number. It is best if each
transponder has a signal strength above 70.
If you have an Oval, 2 or 3 satellite dish antenna, you can check the signal strength from
transponders on each satellite.
To change the selected satellite, press the UP arrow until the satellite number is
highlighted. Press the RIGHT or LEFT arrow to change the satellite.
Press the DOWN arrow to highlight the transponder number, then press the LEFT or
the RIGHT arrow to check the signal on different transponders.
If your signal strength is low, see “Satellite Signal Troubleshooting,” on see page 28.
Repeat Satellite Dish Guided Setup. After selecting this, you need to enter a safety code
(press THUMBS DOWN three times, then press ENTER). This option lets you repeat
Satellite Dish Guided Setup. For more information, see page 25.
Reset Satellite Information. Only use this feature if directed to do so by a professional
installer or a DIRECTV customer care representative. In most cases, you can use Satellite
Dish Guided Setup, rather than this option.
DIRECTV Central Messages and Setup Recorder & Phone Setup Satellite Dish Setup
Users_Guide_DTV3.1.book Page 100 Wednesday, June 4, 2003 7:08 PM