Filter
Top Products
1. Locate the A/V output jacks on the camcorder. They are usually found on the side or back of the
camcorder.
Connect a set of audio cables between the AUDIO OUTPUT jacks on the camcorder and the
AV IN
[R-AUDIO-L]
on the Monitor.
2. Connect a video cable between the VIDEO OUTPUT jack on the camcorder and the
AV IN [VIDEO]
on the Monitor.
3. Select
AV
that is connected to a Camcorder using the Source button on the monitor's front or
remote control.
4. Then, start the Camcorders with a tape inserted.
The audio-video cables shown here are usually included with a Camcorder.
(If not, check your local electronics store.)
If your camcorder is stereo, you need to connect a set of two cables.
5. Connecting DTV Set Top Box
The connections for a typical Set Top Box are shown below.
1. Connect a set of audio cables between the
COMPONENT AUDIO IN [R-AUDIO-L]
on the Monitor
and the AUDIO OUT jacks on the Set Top Box.
2. Connect a Component cable between the
BNC/COMPONENT IN - P
R
, Y, P
B
port
on the Monitor
and the P
R, Y, PB jacks on the Set Top Box.
3. Select
Component
that is connected to a DTV Set Top Box using the Source button on the
monitor's front or remote control.
For an explanation of Component video, see your Set Top Box owner's manual.
6. Connecting Speakers
1. Tighten the SET and the speaker using the screws.