Filter
Top Products
INSTALLATION
English - 15
Connecting Cable TV
To connect to a cable TV system, follow the instructions below.
Cable without a Cable Box
1
Plug the incoming cable
into the “ANT 2 IN (Cable)”
terminal on the rear panel.
2
Plug the combiner into the
“ANT 1 IN (Air)” terminal
on the rear panel.
Separate VHF and UHF Antennas
If you have two separate antennas for your TV (one VHF and one UHF), you must
combine the two antenna signals before connecting the antennas to the TV. This
procedure requires an optional combiner-adaptor (available at most electronics shops).
1
Connect both antenna
leads to the combiner.
Antennas with 75-ohm Round Leads
1
Plug the antenna lead into
the “ANT 1 IN (Air)”
terminal on the rear panel.
AA68-03652A-00Eng 5/30/05 9:38 AM Page 15