Filter
Top Products
INSTALLATION
English - 18
Connecting a VCR
These instructions assume that you have already connected your TV to an antenna
or a cable TV system (according to the instructions on pages 14~17).
1
Connect a coaxial cable between the
“ANT 1 IN (Air)” terminal on the TV and
the antenna out terminal on the VCR.
A coaxial cable is usually included with
a VCR. (If not, check your local
electronics store).
2
Connect a set of audio cables between
the “AV IN 1 (L, R)” (or “AV IN 2/3 (L,
R)”) jacks on the TV and AUDIO OUT
jacks on the VCR.
If you have a mono VCR, connect
L(mono) to VCR audio out using only
one audio cable.
3
Connect a video cable between the “AV
IN 1 (VIDEO)” (or “AV IN 2/3 (VIDEO)”)
jack on the TV and the VIDEO OUT jack
on the VCR.
Refer to your VCR’s instructions for
more information about how to view
your VCR tape.
TV Rear Panel
• Also, you can connect to “AV IN 4” on the side panel of TV.
AA68-03652A-00Eng 5/30/05 9:38 AM Page 18