Filter
Top Products
19
■ Switching into / from standby mode
The Standby mode is used for switching the TV set off for short
periods of time. In standby mode the TV is switched off but is
still receiving mains power.
● To turn the TV set into standby mode, press the
4
button.
The red power indicator illuminates more brightly.
● To turn the TV set ON from standby mode, press any of the
following buttons:
4
,
5
,
6
or
0-9 buttons.
■ Auto shut off
This TV set will automatically switch into the standby mode, 10
minutes after a signal is no longer received. The time until the
set will switch off is displayed on the screen.
■ Use of Audio Output Jacks
This TV provides the audio monitor output jacks on the left side
of the cabinet. You can connect your audio equipment to these
jacks to give you sound with your audio equipment.
The Digital shot function allows you to capture and store up to 12
pictures in an album. You can view them as a slide show or
individually.
■ How to capture a picture in Digital shot
Press the DS button on the remote control to capture the picture.
1 / 12 will appear on the screen and the picture will be stored in the
Album. The album can store up to 12 pictures.
■ How to view pictures in Digital shot
Press the CS button to view the picture Album.
Use the cursors
7, 8, e, d to highlight a picture for selection.
Press the OK button to display a full screen.
Use the cursors 7, 8 to cycle through the picture.
Press the OK button to show the menu or the Blue button to return
to Album.
● Auto Album
Press the Green button to select Auto album. A slide show will begin
from the highlighted picture. eg. 1-2-3-1-2-3.
If you wish to stop while auto album is activated press the green but-
ton and it will stop.
To reactivate press the Green button again.
Press the Blue button to return to view digital shot pictures (Album).
Press the CS button to return to normal TV picture.
● To delete
Press the Red button to Delete all saved pictures.
Select a picture already saved, then press the yellow button to
delete a single image.
Press the CS button to return to normal TV picture at any time.
✐
The pictures that are saved in Auto Album will be deleted when
the power is disconnected.
ANALOGUE
ANALOGUE
AND DIGIT
AND DIGIT
AL
AL
OPERA
OPERA
TION
TION
If you find the power indicator flashing, please turn the TV
set off with the Standby switch and disconnect the power
cord from the power outlet and contact our Service desk.
This warning is a sign to let you know that the power
protection function of this TV set is now operating.
AV1
AV2
L/S
R/D
AV3
To audio equipment
Digital shot function
1
: Delete All : Delete
: Auto Album
OK : Select
CS : Exit
Album