Sanyo SRT-4040 VCR User Manual


 
NORMAL RECORDING
Normal Recording
Before starting
œ Turn the power on to all devices used.
œ Load a cassette tape with its erasure-prevention tab
intact.
œ Set the ON SCREEN switch to the ON position.
NOTES:
œ If “TAPE IN MODE” is set to “REC” in the
(GENERAL SET) menu, recording will start.
œ Set the TAPE item in the (GENERAL SET)
menu according to the duration of the tape used.
1
Press the REC/PLAY SPEED l button to set the
recording speed mode.
ø The recording speed mode appears on-screen
and on the digital display.
2 Press the REC button.
ø The record indicator a lights.
ø Recording starts.
ø If the tape end is reached while recording,
OFF is displayed on the digital display and the
unit goes into the mode set at the TAPE END
MODE setting in the (GENERAL SET) menu.
To cancel the OFF display, press the STOP,
EJECT, FF, REW or PLAY button.
ø When the end of the tape is reached, the TAPE
END OUT terminal output will be 0V. To cancel
the output, press the STOP button.
3
To stop recording, press the STOP button.
NOTES:
œ A tape recording made on this VCR may not play
back with the same degree of clarity on a real time
video cassette recorder from another manufacturer.
œ If you press the REC button and the loaded cassette
has no erasure-prevention tab, the VCR will eject the
cassette.
[Recording Speed Mode]
(When the “TAPE” is set to “T-160” in the (GENERAL
SET) menu)
Recording
speed mode
(hour mode)
Maximum
recording
duration
(hours)
Recording
interval
(second)
Audio
recording
Tape motion
8 8 1/60
Possible Continuous 24 24 3/60
40 40 5/60
000 Single image recording Not possible Intermittent
(When the “TAPE” is set to “T-120” in the (GENERAL
SET) menu)
Recording
speed mode
(hour mode)
Maximum
recording
duration
(hours)
Recording
interval
(second)
Audio
recording
Tape motion
6 6 1/60
Possible Continuous 18 18 3/60
30 30 5/60
000 Single image recording Not possible Intermittent
NOTE:
œ The tape speed display will vary according to the
TAPE item in the (GENERAL SET) menu setting. In
this manual, all the examples and displays used are
for when the TAPE item is set to “T-160”. If set to
“T-120”, please refer to the table above for the
corresponding durations and displays.
For example, if the recording speed mode is “8”, then
the corresponding recording speed when set to
“T-120” will be “6”, and, the counter reading of 8:00:00
will be 6:00:00 when set to “T-120”.
NB4QR/NA (SRT-4040 GB) Tue. Sept., 10/2002
20
English