Filter
Top Products
HEAD SWITCHING FUNCTION
This unit is equipped with 4 double azimuth heads.
Under normal conditions, recording and playback is done
using the main heads “A1” and “B1”.
If a problem occurs with the main heads, for example if
only one channel is being recorded and playback cannot
be done, you can temporarily switch to the secondary
heads so that the playback picture can be viewed.
(If a problem occurs with the main heads, it is
recommended that you have the unit repaired as soon
as possible.)
Switching heads combination and azimuth
display
The heads that are used can be switched to any of the
combinations (1, 2 or 3) indicated in the table below,
until the playback picture can be viewed. When switching
to a combination other than the main heads, the
corresponding azimuth indicator will be displayed.
1
Start playback.
2
Press and hold the MENU button, then press the
PLAY button.
3
Release the button.
ø The selected heads combination will change in
the order indicated in the table below.
To select another head combination, repeat steps 2
and 3 above.
Heads
combination
Azimuth indicator
1 A1 and A2 +
2 B1 and B2 –
3 A2 and B2 1
4 A1 and B1 No indicator (Normal head
combination)
NOTES:
œ When the end of the tape is reached, the head
combination automatically returns to the normal
setting. The head combination will also automatically
return to the normal setting when the tape is stopped,
the cassette is ejected or after a power interruption.
œ When using the head combination 1 or 2 during
playback, note the following points.
3-hour mode
The image is close to normal, but there will be
some shaking in the vertical direction.
12 or 24-hour mode
Noise bars will be visible
48 - 960-hour mode
Noise bars will appear and disappear
Field advance
Noise bars will appear and disappear
A1 (main)
A2 (secondary)
B2 (secondary)
B1 (main)
1 234
Azimuth indicator
RQ4Q/EX (TLS-1960P GB) Wed. May, 08/2002
English
49