Filter
Top Products
573497 Rev B
6
Setting up the remote control to operate your TV
To make the remote control work with your TV, follow this procedure.
Important! If you are using a TV/VCR combination, you should use the
VCR or TV/VCR combination codes. Go to Setting up the remote
control to operate your VCR on the next page.
1. Find the code for your brand of TV in the back of this guide. You
may find more than one code for your particular brand. Start
with the first choice. Remember: If you are using a TV/VCR
combination, use a VCR or TV/VCR combination code.
2. Press and release
TV
, then hold down
SET-UP
until
the red light blinks twice.
Note: You may need to wait a few seconds for the
red light to blink twice.
3. Enter your 3-digit TV code–the red light should
blink twice again. (If the red light does not blink
twice, return to step 1 and try again.)
4. Point your AllTouch Remote Control at your TV
and press
POWER
.
5. Did your TV turn off (or on)?
• If yes, you are finished setting up the remote
control for your TV. Write your TV code on
page 31.
• If no, go to step 6.
Notes:
• You may want to press VOL ▲▼, MUTE, and CH ▲▼ to
verify that all functions work.
• To disable channel control in TV mode, turn to Disabling/
enabling channel control on page 16 and follow the steps.
6. If your TV did not respond, repeat steps 2 through 5 trying all of
the codes (one at a time) under your brand.
7. If your TV still did not respond, turn to All Search on page 10
and follow the steps.
VCR
1
4
7
2
5
8
0
3
6
9
AUX
V
O
L
SELECT
REW
PAUSE RECSTOP
PLAY FF
SET-UP BYPASS
MENU INFO
PPV
PREV. DAY NEXT DAY
M
U
T
E
L
A
S
T
FAV
POWER
BAC
TV
CBL
C
H
T6054
SET-UP
TV
G
U
I
D
E