Filter
Top Products
8
Setting Up VCR Commander Service
Use your Explorer Remote Control to set up the VCR Commander
service.
After you connect the IR Blaster, you must program the code for
your brand of VCR into the memory of the VCR Commander.
Before you begin
• Be sure the VCR is off
• Be sure the TV is on and tuned to your cable channel (3 or 4)
Note: At any time during this procedure, you can press or
to manually record a program on your VCR.
Continued on next page
EXIT
C
General Settings
Highlight a Preference, press SELECT to change its setting(s).
Timer: All
Timer: Remind New
Timer: Sleep
Set: Bypass
Set: Color Scheme
Set: Output Chan
Set: VCR Comnder
Disabled
CURRENT STATUS
PREFERENCE
General Settings
Highlight a Preference, press SELECT to change its setting(s).
Set: Bypass
Set: Color Scheme
Set: Output Chan
Set: VCR Comnder
Timer: All
Timer: Remind New
Timer: Sleep
Disabled
CURRENT STATUS
PREFERENCE
General Settings
Highlight desired VCR Commander setting, press SELECT to change.
Disable
Setup
Enable
Set: VCR Comnder
STATUS
PREFERENCE
Cancel Changes
Accept
1. Turn on the power to your
Explorer
DHCT.
2. Press twice to display
the General Settings menu.
SETTINGS
4. Press s or t to scroll to Setup;
then, press .
SELECT
3. Press s or t to scroll to the
Set: VCR Commander
preference; then, press .
Note: If the menu does not
display the VCR Commander
option, contact your cable
service provider.
SELECT