Filter
Top Products
p
Disc Playback
Before Starting Playback
Loading the Batteries in the Remote
Control
Press down on the tab in the direction of the
arrow to remove the battery cover.
1
Load the two R-03 size batteries (“AAA” size,
UM/SUM-4) supplied with the remote control
unit. Make sure that the battery poles m and n
are positioned as indicated.
2
Slide the battery cover in the direction of the
arrow until it clicks.
3
NOTE
• Do not subject the remote control unit to shock, water or
excessive humidity.
• The remote control unit may not function if the Player's remote
sensor is in direct sunlight or any other strong light.
• Incorrect use of batteries may cause them to leak or burst. Read
the battery warnings and use the batteries properly.
• Do not mix old and new batteries, or mix different brands.
• Remove the batteries if you will not use the remote control unit for
an extended period of time.
Remote control sensor
Remote control unit
Approximate operating range of remote
control
30º 30º
7 m
Connecting the Power Cord
Plug the supplied AC cord into the AC IN terminal on the rear
of the Player. Then plug into AC outlet.
NOTE
• Place the Player close to the AC outlet, and keep the power plug
within reach.
• TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH THE
UN-INSULATED PARTS OF ANY CABLES WHILE THE AC CORD
IS CONNECTED.
• The a (STANDBY) indicator blinks while the Player is preparing for
starting up. You cannot turn the Player on until the a (STANDBY)
indicator stops blinking.
To AC IN terminal
To AC outlet
21
BD-HP20H_en_c.indd 21BD-HP20H_en_c.indd 21 2007/09/27 16:17:232007/09/27 16:17:23