Sharp BD-HP50U Blu-ray Player User Manual


 
20
Loading the Batteries in the Remote
Control
Press down on the tab in the direction of the
arrow to remove the battery cover.
Load the two “AAA” size batteries (R-03 size,
UM/SUM-4) supplied with the remote control
unit. Make sure that the battery poles m and n
are positioned as indicated.
Slide the battery cover in the direction of the
arrow until it clicks.
NOTE
Do not subject the remote control unit to shock, water or
excessive humidity.
The remote control unit may not function if the Player's remote
sensor is in direct sunlight or any other strong light.
Incorrect use of batteries may cause them to leak or burst. Read
the battery warnings and use the batteries properly.
Do not mix old and new batteries, or mix different brands.
Remove the batteries if you will not use the remote control unit for
an extended period of time.
1
2
3
Connecting the Power Cord
Plug the supplied AC cord into the AC IN terminal on the rear
of the Player. Then plug into AC outlet.
NOTE
Place the Player close to the AC outlet, and keep the power plug
within reach.
TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH THE
UN-INSULATED PARTS OF ANY CABLES WHILE THE AC CORD
IS CONNECTED.
The STANDBY indicator blinks while the Player is preparing for
starting up. You cannot turn the Player on until the STANDBY
indicator stops blinking.
Before Starting Playback
Approximate operating range of remote
control
Remote control sensor
Remote control unit
To AC IN terminal
To AC outlet
30º
7 m
30º
Disc Playback
BD-HP50U_en.indd 20BD-HP50U_en.indd 20 2008/07/17 19:57:592008/07/17 19:57:59