Sharp BD-HP90S Blu-ray Player User Manual


 
Before Starting Playback
Loading the Batteries in the
Remote Control
Hold in the tab on the battery cover and pull the
cover towards the direction of the arrow.
Load the two “AAA” size batteries (R-03 size,
UM/SUM-4). Place batteries with their terminals
corresponding to the m and n indications in
battery compartment.
Insert the smaller tab of the battery cover into
the opening 1, and press down on the cover
until it clicks in place 2.
NOTE
Do not subject the remote control unit to shock, water or
excessive humidity.
The remote control unit may not function if the Player's
remote sensor is in direct sunlight or any other strong light.
Incorrect use of batteries may cause them to leak or burst.
Read the battery warnings and use the batteries properly.
Do not mix old and new batteries, or mix different brands.
Remove the batteries if you will not use the remote control
unit for an extended period of time.
WARNING
Do not use or store batteries in direct sunlight or other
excessively hot place, such as inside a car or near a heater.
This can cause batteries to leak, overheat, explode or
catch fire.
It can also reduce the life or performance of batteries.
1
2
3
30º
º03º03
30º
Approximate operating range of
remote control
You can select the remote control sensor used
depending on the orientation of the player. See page
19 to switch the remote control sensor.
Playback
24
Remote control sensor
c Remote control unit
Approx. 7 m from
the sensor
*
30º
º03º03
30º
30º
º03º03
30º
c Remote control unit d
Remote control sensor
Remote control sensor