Sharp F657WJZZ Flat Panel Television User Manual


 
You can convert normal 2D images into 3D images (3D
effect).
1 Press 3D button on remote control.
2 Press a/b to select "2D->3D""on", and then
press ;.
3 Turn on the power of the 3D glasses, and then
wear the 3D glasses.
Watching 2D images in 3D
Enjoying 3D image viewing
When the TV receives a 3D image signal that cannot be
detected automatically, you can select between 3D and
2D image viewing.
1 Select the 3D source (HDMI).
2 Press 3D button on remote control. The following
screen appears.
3 Press c/d to select “side by side” , “top/
bottom” or “Games”, and then press ;.
E To view in 3D mode ("side by side" or
"top-bottom")
1
Press c/d to select the 3D signal type (“side
by side” or “top/bottom”), and then press ;.
• If you select the same system as that of the input
signal, 3D images are displayed.
2 Turn on the 3D glasses switching them to "3D"
and then wear the 3D glasses.
The LED lights up green.
E To view in 2D mode
To view 2D mode without glasses:
1 Press a/b to select "
off”
, and then press
;.
To view 2D mode some of you at the same time than
other people are viewing 3D mode:
1 Follow up the step 1 of previously described
in "
To view in 3D mode ("side by side"
or "top-bottom")
".
2 Turn on the 3D glasses switching to "2D" and
then wear the 3D glasses.
The LED lights up green.
NOTES
After approximately 10 minutes without receiving 3D signal
the 3D glasses turn off automatically.
To power off the power of 3D glasses, switch them to Off.
The LED will also turn off.
Receiving a 3D image signal that
cannot be detected automatically
Recharging the 3D glasses battery
When the battery power is low, the LED light blinks one
time per second. If the 3D glasses battery runs out,
you can recharge the 3D glasses battery by connecting
the USB-mini USB cable, supplied with glasses, to any
of the TV set side USB terminals or any other pr
oper
source.
When the LED light goes off, the recharge is complete.
NOTE
If the input signal switches to 2D, 2D images are
displayed automatically.
3D mode is cancelled automatically when: the
setting is changed, the input source is changed,
the input signal resolution is changed or the power
is turned off.
55
(HDD)
USB