Filter
Top Products
Function setup
Some discs are specified as not suitable for children.
Playback of such discs can be restricted with this
TV/DVD.
1 Select"Parental", then press • or ENTER.
"Enter Password" screen will appear.
Press "0000" using Number buttons (0-9).
(Please note, this is pre-setting password of this
unit). Then press ENTER. The parental level list
will appear.
• Ifyou inputa wrongnumber,pressCANCEL.
Level Off
Level 8
Level 1
The parental control setting does not
function.
Virtually all DVD software can be
played back.
DVD software for adults cannot
be played back.
• Select from level 1 to level 8. The limitation wil! be
more severe as the level number decreases.
3 Press A/T to select from the level 1 to level 8. The
limitation will be more severe as the level number
is lower. Then press ENTER.
4 Press SETUP to return to the normal screen.
• Afterthe ratingislocked,the settingcannot be
changed unlessyouenterthe correctpassword.
Depending on the DVD disc, the disc may try to
temporarily cancel the rating level that you have set.
It is up to you to decide whether to cancel the rating
level or not.
1 Load a DVD disc. (See page 25.)
If the DVD disc has been designed to temporarily
cancel the rating level, the screen which follows the
"Reading" screen will change, depending on which
disc is played. If you select "YES" with pressing
ENTER, password input screen will then appear.
Enter the password with Number buttons (0-9).
Then press ENTER.
• Ifyou interruptthe entering,pressRETURN.
4 Playback will commence if the entered password
was correct.
• This temporary cancellation of the rating level wil! be kept
until the disc is ejected.
When the disc is ejected, the original rating level wil! be
set again automatically.
• The password is required every time when you change the
parental level.
• Depending on the discs, the TV/DVD may not be able to
limit playback.
• Some discs may not be encoded with specific rating level
information though its disc jacket says "adult." For those
discs, the parental control feature will not work.
1 Select"Password", then press • or ENTER.
"Enter Current Password" screen will appear.
2 Press Number buttons (0-9) to enter the
password you have stored.
• Ifyou inputa wrong number,pressCANCEL.
3 Then press ENTER. "Enter New Password" screen
will appear. Press Number buttons (0-9) to input
the new password.
4 Press ENTER. Now your new password has been
set. Be sure to remember this number!
If you forget the password...
1.Press EJECT to remove the disc.
2.While holding 7 down on the remote control and at the
same time press STOP on the front panel. "Password
Clear" appears on the screen. Now the password has
been returned to the initial value ("0000").
- 32
50Q0131A Eindb 32 3/3/2008 1:43:36 PM