Filter
Top Products
49
Removing the stand
Before detaching (or attaching) stand, unplug the AC cord from the AC INPUT terminal.
CAUTION
• Do not remove the stand from the TV unless using an optional wall mount bracket to mount it.
Before attaching/detaching stand
• Before performing work make sure to turn off the TV.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being
damaged.
Setting the TV on the wall
CAUTION
• This TV should be mounted on the wall only with the AN-37AG2/AN-52AG1 (SHARP) wall mount bracket. The use
of other wall mount brackets may result in an unstable installation and may cause serious injuries.
• Installing the TV requires special skill that should only be performed by qualifi ed service personnel. Customers
should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting or
mounting that results in accident or injury.
Using an optional bracket to mount the TV
• You can ask a qualifi ed service professional about using an optional AN-37AG2/AN-52AG1 bracket to mount the
TV to the wall.
• Carefully read the instructions that come with the bracket before beginning work.
Hanging on the wall
AN-37AG2/AN-52AG1 wall mount bracket.
(See the bracket instructions for details.)
Vertical mounting
Unfasten the four screws used to secure the stand in
place.
Detach the stand from the TV. (Hold the stand so it will
not drop from the edge of the base area.)
Appendix
NOTE
• To attach the stand, perform the above steps in reverse order.
Angular mounting
12
Hex key
NOTE
• Detach the cable clamps on the rear of the TV when using the optional mount bracket.
About setting the TV angle and height adjustment
0° or 5°
1 0/5/10/15/20°
2 f5/0/e5 cm
(can be moved
5 cm up or
down)
AN-37AG2 AN-52AG1
For AN-52AG1