Filter
Top Products
34
1 2 3
4 5 6
7 8 9
0
100
POWER
TV
VCR
MENU MUTE
CATV
PAUSE
TV
FLASHBACK
DISPLAY
INPUT
TV ¥ VCR ¥ CATV
STOP REC
REW PLAY FF
VCR CH
VOL
CH
CH
VOL
+
ENTER
A B C D
PERSONAL PREFERENCE
VCR POWER
Press to turn the VCR on
and off.
PLAY
Press to playback a tape.
REWIND
Press to rewind a tape.
For some VCRs you may
need to press STOP first,
then REWIND.
In Playback mode, hold
button down to view picture
moving rapidly in reverse.
PAUSE
Press to temporarily stop
the tape during playback
or recording. Press again
to release Pause.
STOP
Press to stop the tape.
REMOTE KEYPAD
Use to enter two-digit code
numbers when identifying your
VCR.
ENTER
FF
Press to rapidly advance the
tape. For some VCRs, you may
need to press STOP first, then
FF.
In Playback mode, hold button
down to view the picture moving
rapidly in forward direction.
VCR CHANNEL
UP ( ) / DOWN ( )
Press to scan up or down through
channels on the VCR.
RECORD
Press to begin recording.
Operation of Remote Control
L Universal Remote Control
With the purchase of your television set you
also have received the latest innovation in
remote control technology. With its easy-to-
use push-button keypad, your Remote can
control your television set and most infrared
remote-controlled VCRs and cable TV
converters as well.
• Depending on the model, year produced,
brand and type of VCR, some models may
not be compatible with the remote control.
• Some brands of VCR or Cable TV converter
Box may not enable channel selection until
the ENTER is pressed.
Example:
When you select channel 24,
(1) Press REMOTE KEYPAD “2”.
(2) Press REMOTE KEYPAD “4”.
(3) Press ENTER.
For detailed information on the use of the VCR
or Cable TV converter Box refer to their
operating manuals.
L Using Your Remote With Your TV
After installing the batteries, set the
TV-CATV
on the remote to the TV position. (If you can
change the channel of the TV by pressing
CH UP
(
8
) or
DOWN
(
9
) on the Remote
Control, it is in the TV position.)
L “ Identifying” Remote VCR and Cable TV
Converters
Your Remote Control has been set at the
factory to operate your TV and many remote
control VCRs and Cable Converters. However,
in some cases an easy one-time set-up step
may be necessary before the Remote will
operate accessory VCRs and Cable
Converters.
• In this set-up step, the Remote locates and
memorizes the remote control transmitter code
for the VCR or Cable Converter.
• Once “identified”, the Remote sends the proper
remote signals to operate your accessory.
• This identify step will not have to be repeated
until power to the Remote is interrupted due
to a battery failure.
L Using Your Remote Control With a VCR
Once you make certain the Remote Control
has “identified” your remote controlled VCR,
the Remote Control is ready to operate your
unit. The various VCR function buttons on the
Remote Control will not operate your VCR
if those features are not already found on
your unit.
• All VCR buttons will operate whether the
Remote Control is in TV or CATV modes.
• For detailed information on the use of the VCR,
refer to the operation manual of the VCR.
NOTE:
32-40 25&27NS100/180 1.4 6/1/00, 2:12 PM34