Filter
Top Products
9
Before turning on the power
RF IN
RF OUT
USB
ETHERNET
SPDIF
HDMI
VCR
DC 12V DC
-
+
TV
IN
RS-232OPTICAL
DOLBY
HIGHDEFINITIONMULTIMEDIA INTERFACE
Connect the antenna (standard DIN45325 plug (IEC 169-2) n
75 q coaxial cable)
Connect the HDMI cable
o
Connect the p p ower adapter
Place the TV close to the AC outlet,
and keep the power plug within
reach.
Initial auto installation
When the Recorder is powered on for the first time after purchase, the first time installation screen appears. Follow the
on-screen instructions to search for all available channels.
Confirm the following before turning on the power
Is the antenna cable connected? E
Is the power adapter connected and plugged in? E
Is the HDMI cable connected between the Recorder and your TV? E
Press 1 a on the Recorder.
The first time installation screen is displayed.•
Ensure the antenna cable is connected. 2
Press OK to start the channel search. 3
The Recorder will search for, sort and store all •
receivable channels.
NOTE
The first time installation process will be aborted if the •
Recorder is left unattended for more than 30 minutes before
searching for channels.
After the first time installation has been completed, the •
default PIN is automatically set to ‘0000’. To change the PIN
setting, refer to Page 22.
First Time Installation
OK
Please ensure that an aerial is connected
Then press to scan for services
Quick guide
n
o p
TU-T2HR32_GB.indd 9TU-T2HR32_GB.indd 9 29/06/2010 15:16:1529/06/2010 15:16:15