Filter
Top Products
14
Location and Function of Parts
Chapter 1 Overview
Playback modes using the search dial
You can use the SEARCH ENABLE menu item (see page
39) to select either of the following as the operation to be
performed to put the unit into search mode (shuttle or jog).
• Either press the SEARCH button or turn the search dial
(factory default setting).
• Press the SEARCH button.
E Remote control setting section
Note
When you edit using the DV IN/OUT connector, with
video and audio signal input set to “i.LINK” and remote
control set to “9PIN”, the locations where edit points are
actually set may not be the same as the specified locations.
When you set video and audio signal input to “i.LINK”, set
remote control to “i.LINK” as well.
a REMOTE button
When remote-controlling this unit from the unit connected
to the REMOTE connector (page 18) or DV IN/OUT
connector (page 17), press this button, turning it on.
When reverting to local mode to use the buttons in the tape
transport control section, press this button again, turning it
off.
b 9PIN button
When carrying out remote control between this unit and
the unit connected to the REMOTE connector, press this
button, turning it on.
c i.LINK button
When carrying out remote control between this unit and
the unit connected to the DV IN/OUT connector, press
this button, turning it on.
Playback mode Operation and functions
Shuttle Press the SEARCH button or the search
dial so that the SHUTTLE indicator in
the display section lights, then turn the
search dial.
Playback is carried out at a speed
determined by the position of the search
dial. The maximum shuttle mode
playback speed can be changed with the
SHUTTLE menu item (see page 39).
Jog Press the SEARCH button or the search
dial so that the JOG indicator in the
display section lights, then turn the
search dial. Playback is carried out at a
speed determined by the speed of
rotation of the search dial. The playback
speed is up to
±1 times normal speed by
factory default.
The search dial has no detents.
a REMOTE button
b 9PIN button
c i.LINK button