Filter
Top Products
2-3 Connector Panel
2-16 Chapter 2 Locations and Functions of Parts and Controls
Chapter 2 Locations and Functions of Parts and Controls
!∞ REMOTE1-IN/OUT (9P) connectors
(D-sub 9-pin)
Connect to another DVW-500/1 or 500P/1 VTR or D-
1, D-2, or Betacam VTR through a 9-pin remote
control cable. Used when you edit using two VTRs
and the BVE-900/910/2000/9000/9100 Editing Control
Unit. The REMOTE1-IN and OUT connectors can be
used to make a bridge connection.
!§ MONITOR OUTPUT connectors (XLR-3-31)
Output signals for audio monitoring. These connectors
output two signal lines: L and R. Select the signals to
be output with the MONITOR SELECT buttons and
the AUDIO INPUT/MONITOR SELECT buttons on
the upper control panel. Through an initial setting, you
can enable the adjustment of the volume level with the
PHONES level control.
For details, refer to “5-1-2 Selecting Audio Signals”on page
5-2.
!¶ VIDEO CONTROL connector (D-sub 15-pin)
Connects to the optional BVR-50/50P TBC Remote
Controller to enable remote control of the internal
digital video processor. Before connecting the remote
controller, turn off the power to the VTR.
!• RS-232C connector (D-sub 25-pin)
Receives or transmits RS-232C remote control signals
and/or VTR status data from/to external equipment.
When this connector is being used for communication,
the RS-232C indicator on the upper control panel
lights up.
!ª PARALLEL I/O(50P) connector (D-sub 50-pin,
with optional BKDW-509)
Inputs an external remote control signal.
For details, refer to the Installation Manual.
@º AUDIO OUTPUT (AES/EBU) connectors
(XLR-3-32)
Output a maximum of two lines (four channels:
channels 1/2 and 3/4) of AES/EBU format digital
audio signals.
@¡ TIME CODE OUT connector (XLR-3-31)
Outputs one of the following time codes according to
the VTR operation mode.
In playback mode: Playback time code
In recording mode: Time code generated by the
internal time code generator, or time code input to
the TIME CODE IN connector.
@™ TIME CODE IN connector (XLR-3-32)
Accepts an external time code for recording to tape.
Connect to the time code output connector of the
external equipment.