Sony BKDW-505/506 DVR User Manual


 
Chapter 5 Recording/Playback 5-13
Chapter 5 Recording/Playback
5-4-5 Program Playback
In program playback mode, you can play back a tape at
a previously determined speed. This speed may be set
within a range of normal playback speed ±15% (in
0.1% steps).
Installation of the optional BKDW-507 Audio
Program Play Board allows you to obtain higher
quality audio output during program playback.
Before performing program playback
Set 111. PROGRAM PLAY in the VTR SETUP menu
to enable.
Performing program playback
1 Press the search dial or the JOG button to light up
the JOG button, press the ALT button, and then
rotate the search dial while holding down the [F8]
(P-PLAY) button to specify the playback speed.
The adjustment range is ±15% normal playback
speed.
2 Press the PLAY button while holding down the
[F8] (P-PLAY) button.
The [F8] (P-PLAY) button lights up, and program
playback starts.
You can change the playback speed during
program playback by rotating the search dial while
holding down the [F8] (P-PLAY) button.
3 Press the STOP button to stop program playback.
Program play mode is canceled.
Note that the playback speed during program play
does not change until you change the playback
speed or you turn the power off. Normal playback
speed resumes when you turn the power off, then
on again.
1
32