Filter
Top Products
30
KDL-V32/40A12U
2-629-164-14(1)
Assigns a channel name of your choice up to five letters or numbers. The name will be
displayed briefly on the screen when the channel is selected. (Names for channels are usually
taken automatically from Analogue Text (if available).)
1 Press OK to select “Programme Labels”.
2 Press M/m to select the channel you want to name, then press OK.
3 Press M/m/</, to select the desired letter or number (“s” for a blank
space), then press OK.
If you input a wrong character
Press M/m/</, to select %/5 and press OK repeatedly until the wrong character is
selected. Then, press M/m/</, to select the correct character and press OK.
4 Repeat the procedure in step 3 until the name is complete.
5 Press M/m/</, to select “End”, then press OK.
Assigns a name to any equipment connected to the side and rear sockets. The name will be
displayed briefly on the screen when the equipment is selected. You can skip an input source
that is not connected to any equipment.
1 Press OK to select “AV Preset”.
2 Press M/m to select the desired input source, then press OK.
3 Press M/m to select the desired option below, then press OK.
Before selecting “Label”/“AFT”/“Audio Filter”/“Skip”/“ATT”, press PROG +/- to select the
programme number with the channel. You cannot select a programme number that is set to
skip (page 32).
1 Press OK to select “Manual Programme Preset”.
2 Press M/m to select one of the following options, then press OK.
Programme Labels (Analogue mode only)
AV Preset
Option Description
Equipment labels Uses one of the preset labels to assign a name to connected
equipment.
Edit Creates your own label. Follow steps 3 to 5 of “Programme Labels”
(page 30).
Skip Skips an input source that is not connected to any equipment when
you press M/m to select the input source.
Manual Programme Preset (Analogue mode only)
01GB-KLV40XUK.book Page 30 Wednesday, August 31, 2005 4:42 PM