Filter
Top Products
32
KDL-V32/40A12U
2-629-164-14(1)
Displays the “Digital Set Up” menu. You can change/set the digital settings using this menu.
1 Press OK to select “Digital Set Up”.
2 Press M/m to select the desired icon below, then press OK.
3 Press M/m to select one of the following options, then press OK.
Skip Skips unused analogue channels when you press PROG +/- to
select channels. (You can still select a skipped channel using the
number buttons.)
1 Press M/m to select “Yes”, then press OK.
2 Press m to select “Confirm”, then press OK.
3 Press m to select “OK”, then press OK.
To restore a skipped channel, select “No” in step 1.
ATT Attenuates the RF signal. In case of a strong RF signal, some video
interference may be displayed.
1 Press M/m to select “On”, then press OK.
2 Press m to select “Confirm”, then press OK.
3 Press m to select “OK”, then press OK.
Note
When “ATT” is set to “On”, picture noise may occur during VCR
recording when turning on/off the TV or selecting a TV channel.
In this case, connect your aerial to the input socket on your VCR, then
connect the output socket on your VCR to the socket on the rear of
the TV. Confirm that the VCR can record the digital channels.
Digital Set Up
Option Description
Digital Tuning Tunes in all the available digital channels.
Usually you do not need to do this operation because the channels
are already tuned when the TV was first installed (page 13).
However, this option allows you to repeat the process (e.g., to
retune the TV after moving house, or to search for new channels
that have been launched by broadcasters).
1 Press OK to start digital auto-tuning.
When all available digital channels have been tuned, a message
stating that the auto-tuning process is finished appears.
2 Press < .
Digital Auto
Tuning
Option Description
Programme List Edit
Digital Manual Tuning
Digital Auto Tuning
Digital Tuning
Select:Back: Enter:
OK
Digital Tuning menu
01GB-KLV40XUK.book Page 32 Wednesday, August 31, 2005 4:42 PM