Sony DSR-1800 DVR User Manual


 
56
Menu Contents
Chapter 4 Menu Settings
Menu Contents
Setup Menu
The purpose and settings of the setup menu items are
described below.
Indications of menu items and settings
In the table below entitled Menu contents, the
indication of each menu item or setting on the monitor
screen is shown first, then the indication of the same item
or setting in the time counter display of this unit is shown
in square brackets ([ ]).
Settings preceded by an asterisk (such as *EE) are
factory default settings.
In the time counter display, one to three > symbols
may precede item or setting indications depending on the
current menu level. Larger numbers of > symbols
indicate lower menu levels.
Menu contents
Examples:
Indication on monitor
screen
Indication in time counter
display
OPERATIONAL FUNCTION [Operational]
CASSETTE OUT [>> Cass. out]
*
EE
[>>> EE]
OPERATIONAL FUNCTION [Operational]: Operation
settings
Description of settings
REPEAT FUNCTION [>REP
FUNC]: Make settings for
repeat playback mode.
REPEAT MODE
[>>REPEAT MD]:
Determine whether or
not to put the unit into
repeat playback mode.
*OFF [>>> OFF]: Do not put the unit into repeat playback
mode.
ON [>>> ON]: Put the unit into repeat playback mode.
ON (FREEZE) [>>> FREEZE]: Put the unit into freeze
playback mode. In this case, while the unit is cueing up to
the repeat start point, the freeze picture of the repeat end
point is displayed.
REPEAT TOP [>>REP
TOP]: Determine
whether the repeat
start point is the
beginning of tape or
point A.
*TAPE TOP [>>>Tape top]: The repeat start point is the
beginning of tape.
A POINT [>>>A point]: The repeat start point is point A as set
by the user.
REPEAT END [>>REP
END]: Determine
whether the repeat end
point is the end of the
video recorded portion,
the end of tape or point
B.
*VIDEO END [>>>VD end]: The repeat end point is the end
of the video recorded portion.
TAPE END [>>>Tape end]: The repeat end point is the end of
tape.
B POINT [>>>B point]: The repeat end point is point B as set
by the user.
A PRESET [>>A preset]:
Specify a time code
value to be used as the
setting of point A.
For details, see Setting Points A and B for Repeat Playback
on page 34.
B PRESET [>>B preset]:
Specify a time code
value to be used as the
setting of point B.
For details, see Setting Points A and B for Repeat Playback
on page 34.