Filter
Top Products
12
Getting Started
5.1 Channel Surround Hookups
Some DVDs have a sound track with up to 5.1 channels
recorded in Dolby Digital or MPEG audio format. Using a
receiver (amplifier) having 5.1 channel inputs and 6
speakers, you can enjoy a more realistic audio presence in
the comfort of your own home.
“5.1 channel” stands for the 2 front speakers (Left and
Right), 2 rear speakers (Left and Right), 1 center speaker,
and a subwoofer.
Even if you have fewer than 6 speakers, the player
appropriately distributes the output signal to the
speakers.
This player also has a VIRTUAL 3D SURROUND mode.
You can use 3D sound imaging to shift the sound of the
rear speakers away from the actual speaker position
(VIRTUAL REAR SHIFT) or to create 3 sets of virtual rear
speakers from 1 set of actual rear speakers (VIRTUAL
MULTI REAR, etc.). For details on the VIRTUAL 3D
SURROUND mode, see page 34.
Note
When a DVD has a sound track with 7.1 channels recorded in
MPEG audio format, the output audio signals are mixed down to
5.1 channels.
Speaker placement
For the best possible surround sound, we recommend the
following conditions.
• Use higher performance speakers.
• Use rear and center speakers that match your front
speakers in size and performance.
• Place the subwoofer between the front (L, R) speakers if
possible.
Note
Do not place the rear speakers farther away from the listening
position than the front speakers.
Required cords
Audio cords (not supplied) (2)
For the 5.1CH OUTPUT FRONT and REAR jacks
Monaural audio cords (not supplied) (2)
For 5.1CH OUTPUT CENTER and WOOFER jacks.
S video cord (supplied) (1)
For the S VIDEO OUT jack
White (L)
Red (R)
White (L)
Red (R)
When connecting the cords, be sure to match the color-coded
cord to the appropriate jacks on the components: Red (right) to
Red and White (left) to White. Be sure to make connections firmly
to avoid hum and noise.
Do not connect the mains lead to a switched mains such as
the mains on a receiver (amplifier). Doing so may cause the
Playback Memory and menu settings to be cancelled when
you turn off the receiver.
Notes
• Do not connect the mains lead to the mains or press the
POWER switch before completing all connections.
• Refer to the instructions supplied with the component to be
connected.
• The cord connectors should be fully inserted into the jacks. A
loose connection may cause hum and noise.
• If you want to connect the component via the DIGITAL OUT
OPTICAL or COAXIAL connector using an optical or coaxial
digital connecting cord (not supplied), see page 10.
Setups for the player
Some setup adjustments are necessary for the player
depending on the components to be connected.
Use the setup display to change the various settings.
For details on using the setup display, see page 46.
• To enjoy Dolby Digital surround sound by
connecting the player to a receiver (amplifier) with
5.1 channel inputs
Correctly adjust each speaker to your listening position
(page 59).