Filter
Top Products
10
Getting Started
COMPONENT VIDEO OUT
1
2
1
2
YC
B
/B-Y C
R
/R-Y
VIDEO OUT S VIDEO OUT
DIGITAL OUT
COAXIAL OPTICAL
5.1CH OUTPUT
WOOFER
L
R
FRONT REAR CENTER
AUDIO OUT
1
RL
PCM/DTS/MPEG/
DOLBY DIGITAL
2
CD
L
R
DIGITAL IN
OPTICAL
COAXIAL
S VIDEO
VIDEO
AUDIO
INPUT
L
R
Receiver (Amplifier) Hookups
Connect your receiver (amplifier) as follows.
Refer as well to the instructions supplied with the
component to be connected.
zYou can enjoy surround sounds even if you only connect
front speakers
You can use 3D sound imaging to create virtual rear speakers
from the sound of the front speakers (L, R) without using actual
rear speakers (VES: Virtual Enhanced Surround and VIRTUAL
SEMI MULTI DIMENSION). For details, see page 37.
Required cords
Audio connecting cord (not supplied) (1)
S video cord (supplied) (1)
When connecting the cords, be sure to match the color-coded
cord to the appropriate jacks on the components: Red (right) to
Red and White (left) to White. Be sure to make connections firmly
to avoid hum and noise.
White (L)
Red (R)
White (L)
Red (R)
CD/DVD player
To AUDIO
OUT (R, L)
TV
To audio input
: Signal flow
Receiver
(Amplifier)
To mains
To S VIDEO
OUT
To S VIDEO
input
To DIGITAL
OUT
(OPTICAL)
Take off the
cap.
To
DIGITAL
OUT
(COAXIAL)
or
or
To optical digital input
To coaxial digital input
Receiver
(Amplifier) with
a digital
connector, MD
deck, DAT deck,
etc.
If you have a digital component such as a receiver (amplifier)
with a digital connector, DAT or MD, connect the component via
the DIGITAL OUT OPTICAL or COAXIAL connector using an
optical or coaxial digital connecting cord (not supplied).
Optical digital connecting cord (not supplied) (1)
Coaxial digital connecting cord (not supplied) (1)
Do not connect the mains lead to a switched mains such
as the mains on a receiver (amplifier). Doing so may cause
the Playback Memory, Bookmark, Disc Memo and menu
settings to be cancelled when you turn off the receiver.
Note
You cannot enjoy a picture with an S video signal if your TV does
not conform to the S video signal. When your TV does not have
an S VIDEO input, connect the component via the VIDEO INPUT
connector using the video connecting cord (not supplied) instead
of the S video cord. For details, see page 9.
Refer to the instructions supplied with your TV.