Filter
Top Products
3-1
BKDW-515
Section 3
Setup Menu
This section describes the menu ITEM-F series used during adjustment. For the operation and ITEM-H00
to ITEM-900 series, refer to the Operation Manual.
3-1. ITEM-F Series
Display the ITEM-F series according to the procedure below.
1. Press the SETUP key to enter the setup menu.
2. Press the F6 (VTR SETUP) key to enter the VTR SETUP menu.
3. Press the cursor key while pressing the PLAY button.
Item selection
Press the cursor key while pressing the PLAY button and adjust the cursor on the scroll screen to the
arbitrary item.
Data change
Press the F7 (CHANGE DATA) key to open the set change screen and select the data.
Data setting
Press the F10 (SAVE/EXIT) key.
n
These ITEM-F series are exclusively used for adjustment. After adjustment is completed, return data to
the factory setting.
ITEM DATA Description
No. ITEM No. DATA
F01 AUDIO NR IN 0 on This item is prepared exclusively for audio adjustment. After adjustment is
SP MODE 1 switch select completed, return to the factory setting ‘0 (on)’.
Select the type of control to turn Dolby noise reduction ON in the metal tape
playback.
0: Dolby NR is normally ON when mental tape is used.
1: Dolby NR is switched ON and OFF depending upon the DOLBY NR switch
setting on the sub control panel.
(NOTE)
When oxide tape is used, it is controlled depending upon the DOLBY NR switch
setting on the sub control panel, regardless of the setting of this menu item.
F02 EMERGENCY 0 enable This item is prepared exclusively for servo and mechanical adjustments. After
TAPE 1 disable adjustment is completed, return to the factory setting ‘0 (enable)’.
PROTECTION Select whether the emergency tape protection operation is enabled or not when
VTR detects error in tape transport mechanism.
0: Tape protection operation is enabled.
1: Tape protection operation is disabled.
F07 CONFI SELECT 0 disable Selects the playback by the confidence head enable or disable in the normal PB
IN PB MODE 1 enable mode of the digital mode.
0: Disables the playback by the confidence head in the normal PB mode.
1: Enables the playback by the confidence head when the CONFI mode is
entered (the CONFI lamp on the lower control panel lights) in the normal PB
mode.