Filter
Top Products
Setting Up the Channel List
After you finish connecting tile TV, you can run tile Initial Setup to create a
list of available analog and digital channels. The Initial Setup screen appears
when you turn on the TV for the first time after hooking it up. If you choose
to set up the channels at a later time, select the Auto Program option to scan
available channels (see page 66).
'f_ The Auto Program setup in the initial setup does not apply for
installations that use a cable box for all channel selection.
Using Initial Setup To run Initial Setup the first time you turn on your TV
t Press _(_° to turn on tile TV.
The Initial Setup screen appears.
2 Press 4 or ,!, to highlight the on-screen
display language. Then press @. The
message "First please connect cable and/or
antenna" appears. This may require 50+
minutes for completion and "Start auto
program now'?" appears.
3 Press ,i, or ,!. to highlight Ye:
" s"then press @.
Auto Program performed through Initial Setup will automatically create a
list of receivable channels from both VHF/UHF antenna and cable TV
channels if both sources are connected.
,F,_ Auto Program may take a while (20 to 50 minutes) to complete. A
progress bar is displayed while available channels are being
scanned. If you cancel the Auto Program before all receivable
channels are scanned, you may want to perform the task later (see
"To run Auto Program at a later time" below).
,2"_If you selected "No" during the Initial Setup, the Initial Setup
message will appear each time you turn on the TV as a reminder
until you complete the Auto Program.
To run Auto Program at a later time
1 Select Settings in MENU, and then go to Channel settings.
2 Select Auto Program then select Start.
_,_Auto Program will create a list of receivable channels for the
current input (VHF/UHF antenna or CABLE), You will be required to
run Auto Program for each RF inPut to create a list of available
channels from both inputs_
28