Sony KDL-32R400A Flat Panel Television User Manual


 
59
Other Information
PC connection
No picture / No signal Confirm the PC is correctly connected to the TV with the HDMI
IN.
Ensure the output signal from the PC is one of the formats listed
on page 53.
Turn the PC off. Confirm the PC connection and restart the PC.
Plug-and-play will auto-detect the TV and correctly set up PC
timing.
Verify the PC is not in standby or hibernation mode.
Poor Picture Adjust the resolution (see page 53).
General
TV screen feels warm Due to the thin profile of this television, the heat generated by the
LCD panel backlight and supporting electronics will be more
noticeable. This is normal operation and not a cause for concern.
One or more promotional
logo(s) appears (appear)
on the screen. (Demo
Mode)
•Press RETURN on the remote control to suspend Demo Mode.
Then, press HOME, select Settings and proceed with Initial
Setup in the Setup settings. Be sure to select Home on the
viewing environment (Location) step.
Wide Mode changes
automatically
The current Wide Mode setting is automatically replaced with the
4:3 Default setting when you change the channel or video input,
if 4:3 Default in the Screen settings is set to other than Off. If you
want to lock in Wide Mode selected with WIDE on the remote
control, set 4:3 Default to Off in the Screen settings (see page
41).
Check the Auto Wide option in the Screen settings (see page
41).
Suddenly the picture
gets smaller
The picture gets smaller during the commercials due to the
method in which the provider broadcasts their content. When HD
content channels switch to SD content (commercials), the picture
may be small with a black border.
Auto Wide will not expand the picture during these content
changes since the content information is regulated by the
channel signal provider. You can manually change the Wide
Mode if you prefer (see page 30). This setting will remain in
effect until you change the channel or input or manually change
the Wide Mode again.
“Black box” on screen You have selected a text option and no text is available (see
page 48). To turn off this feature, set the CC Display option to
Off. If you were trying to select closed captioning, select CC1
instead of Text1-4.
Condition Explanation/Solution
(Continued)