Filter
Top Products
Using MENU Functions
25
GB
~
“Auto Tuning”, “Programme Sorting” and “Manual Programme Preset” are only available in analogue mode.
L: For France
I: For the United Kingdom
~
Depending on the country/region selected for “Country” (page 6), this option may not be
available.
Channel
1 Press
F/f to select “Channel”, then press .
2 Press
F/f to select “S” (for cable channels) or “C” (for terrestrial
channels), then press
g.
3 Tune the channels as follows:
If you do not know the channel number (frequency)
Press F/f to search for the next available channel. When a channel has been
found, the search will stop. To continue searching, press
F/f.
If you know the channel number (frequency)
Press the number buttons to enter the channel number of the broadcast you want
or your VCR/ DVD recorder channel number.
4 Press to jump to “Confirm”, then press .
Repeat the procedure above to preset other channels manually.
Label
Assigns a name of your choice, up to five letters or numbers, to the selected
channel. This name will be displayed briefly on the screen when the channel is
selected. To input characters, follow steps 1 to 3 of “Edit:” (page 24).
AFT
Allows you to fine-tune the selected programme number manually if you feel
that a slight tuning adjustment will improve the picture quality.
Audio Filter
Improves the sound for individual channels in the case of distortion in mono
broadcasts. Sometimes a non-standard broadcast signal can cause sound
distortion or intermittent sound muting when watching mono programmes.
If you do not experience any sound distortion, we recommend that you leave this
option set to the factory setting “Off”.
~
You cannot receive stereo or dual sound when “Low” or “High” is selected.
“Audio Filter” is not available when “System” is set to “L”.
LNA
Improves the picture quality for individual channels in the case of very weak
broadcast signals (noisy picture).
If you cannot see any improvement in the picture quality even if you set to “On”,
set this option to “Off” (factory setting).
Skip
Skips unused analogue channels when you press PROG +/- to select channels.
(You can still select a skipped channel using the number buttons.)
Decoder
Views and records the scrambled channel selected when using a decoder
connected directly to scart connector
/ AV1, or to scart connector
/ / AV2 via a VCR/ DVD recorder.
~
Depending on the country/region selected for “Country” (page 6), this option may not be
available.
Confirm
Saves changes made to the “
Manual Programme Preset” settings.
010COV.book Page 25 Friday, July 4, 2008 12:56 PM