Filter
Top Products
- 23 -
WA1
RM-Y1108
Service adjustments to this model can be performed using the
supplied remote Commander RM-Y1108.
‘TT—’ will appear in the upper right corner of the screen.
Other status information will also be displayed.
3. Press ‘MENU’ on the remote commander to obtain the following
menu on the screen.
4. Move to the corresponding adjustment item using the
up or down arrow buttons on the Remote Commander.
5. Press the right arrow button to enter into the required menu item.
6. Press the ‘Menu’ button on the Remote Commander to quit the
Service Mode when all adjustments have been completed.
Note :
• After carrying out the service adjustments, to prevent the
customer accessing the ‘Service Menu’ switch the TV set OFF
and then ON.
i+
5
+
(ON SCREEN (DIGIT 5) (VOLUME +) (TV)
DISPLAY)
1. Turn on the power to the TV set and enter into the stand-by
mode.
2. Press the following sequence of buttons on the Remote
Commander.
SECTION 3 SET-UP ADJUSTMENTS
3-1. Signal Adjustment
How to enter into the Service Mode
3-1-1.
PAL auto adjustment (CVBS)
1. Select AV1 and input PAL signal. (PAL CVBS: CB 75%Y/75%C
from signal generator).
2. Change the TV to Personal Mode and set the following registers.
Contrast - 90
Brightness - 50
Colour - 50
3. Set the TV in Service Mode (See above) and send “TT51”
command.
3-1-2.
PAL auto adjustment (RGB)
1. Select AV1 and input RGB signal. (PAL RGB: CB 100%Y/75%C
from signal generator).
2. Change the TV to Personal Mode and set the following registers.
Contrast - 90
Brightness - 50
Colour - 50
3. Set the TV in Service Mode (See above) and send “TT52”
command.
3-1-3.
SECAM auto adjustment (CVBS)
1. Select AV1 and input SECAM signal. (SECAM CVBS: CB 75%Y/
75%C from signal generator).
2. Change the TV to Personal Mode and set the following registers.
Contrast - 90
Brightness - 50
Colour - 50
3. Set the TV in Service Mode (See above) and send “TT53”
command.
Note :
• While Auto adjustment is in process the RED LED is ON, till it
finishes.
3-2. White Balance Adjustment
3-2-1. White Balance adjustment (H/L)
1. Select AV1.
2. Change the TV to Personal Mode and set the following registers.
Contrast - Max
Brightness - 50
Colour - 50
Backlight - Max
3. Input PAL CVBS 70 IRE Full Field Signal to AV1.
4. Enter the ‘SERVICE MENU’ using the cursor keys on the remote
commander.
5. Adjust Highlight registers:
NORMAL_PAL_RD (R Drive)
NORMAL_PAL_BD (B Drive)
High light adjustment value (10500K-6MPCD)
3RH72-VLK egnar
x
8972.0
DNJ8.0
y
3282.0
Y
-A/N
VTLENAPTNEDIRT
REDOCEDAMORHC
THGILKCAB
DNUOS
TSUJDAFI
UNEMECIVRES
UNEMRORRE
92.0v1AW
hFFhFFATADYROTCAF
5927694924:REBMUNLAIRES