Filter
Top Products
- 6 -
WA1
RM-Y1108
WA1 SELF DIAGNOSTIC SOFTWARE
The identification of errors within the WA1 chassis is triggered in one of two ways :- 1: Busy or 2: Device failure to respond to IIC. In the event
of one of these situations arising the software will first try to release the bus if busy (Failure to do so will report with a continuous flashing
LED) and then communicate with each device in turn to establish if a device is faulty. If a device is found to be faulty the relevant device number
will be displayed through the LED (Series of flashes which must be counted).
Flash Timing Example : e.g. error number 3
StBy LED
ON ON
OFF
OFF
LED Error Code
DEL
RORRE
EDOC
NOITPIRCSEDRORRE
20rorrEdraoBA
30rorrEdraoBB
40rorrElenaP
50rorrEMORPEE
60rorrEsuBCII
90rorrErenuT
01rorrErossecorPdnuoS
11rorrEPVS-VTlenaP
21rorrE3612AXC
31rorrE1rednapxEtroP
41rorrE2rednapxEtroP