Filter
Top Products
27
SETUP Setup SETUPSETUP SETUPSETUP
Notes on Using This Connection
To Do This ... Do This ...
Watch the VCR Press TV/VIDEO repeatedly to select the VCR input (VIDEO 1 in the
illustration).
Watch cable channels Press TV/VIDEO repeatedly to select the cable input (VHF/UHF in the
illustration).
Set up the TV remote control
to operate the VCR
If you have a non-Sony VCR, you must program the remote control. See
“Programming the Remote Control” on pages 51-52.
Activate the TV remote
control to operate the VCR
Open the outside cover, as shown on page 50. Then set the A/V slide switch
to the position you programmed for the VCR.
Control VCR functions with
the TV remote control
See “Operating a VCR” on page 53.
Label video inputs to easily
identify equipment connected
to the TV
See the instructions for setting up Video Labels on pages 83-84.
DA4X.book Page 27 Tuesday, April 23, 2002 2:48 PM